CHRYSLER Complaints

Our family was driving and our teen in the third row said his seatbelt came apart. We pulled over to inspect. He was in the third row driver side seat. The stitching for the seatbelt and the seat had disintegrated. There is a sticky residue but no stitching. The leather is in pieces and the seatbelt is unusable. This vehicle is used for family transport so there is no known cause as to why this would have happened. The middle seatbelt stitching is also disintegrating

Vehicle received passenger airbag inflator recall service at Viva CDJR in El Paso, TX. The dash disassembly disturbed adjacent wiring/BCM connections, and after driving, vibration caused a short/ground fault, creating runaway wipers, A/C failure, transmission limp mode, check engine and power steering lights while in transit. Dealer has kept the car for over two weeks and refuses to scan diagnostic trouble codes or inspect the recall-adjacent wiring harness. The vehicle has never experienced this issue prior to the recall service.

Steering sticks on occasion when turning at highway speeds both left and right around the 1 and 10 o'clock position

When in gentle right turns, the steering "sticks" at about 1:00 and I have to apply force to remove the steering wheel from that position. It results in oversteering, particularly at higher speeds.

Mainly driving on highways at the end of long curves the steering is sticky and it is difficult to change the steering wheel back to 12 o'clock. Unpleasant and probably unsafe driving, as overreacting could occur, if it will stick more. It is happening more and more often.

Reference: NHTSA CAMPAIGN NUMBER: PE25009 In the last month, I've noticed steering problem with my mini van. I have to use both hands to steer in a curve and it jerks when coming out of the curve. It feels as if i am loosing control of the van. It also happens when i am changing lanes and steer the wheel past 11 and 1 oclock. It feels as if the car is fighting me to steer.

The head gasket failed at 89,000 miles. The engine gave P0305 Cylinder 5 misfire codes and would run rough causing difficult to drive in standard traffic flow. There are borescope pictures of coolant in cylinder 5. We stopped using the vehicle until the repair can be completed. This appear to be a WIDESPREAD problem for 2017-2019 Chrysler Pacifica which are numerous on the road and could be hazardous if these vehicles failed on regular roads and highways. See [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Rear view back -up camera fails to operate at least once a week. The computer screen does not come on. This problem was subject to a recall last year and supposedly fixed, but it seems to have failed again. This seems to be a radio interference software problem.This is a very serious problem that Chrysler needs to fix correctly. The dealer says unless the problem happens at his shop, they cannot fix it. But it happens occcaisionally so it would be difficult for me to reproduce this. I believe there is a recall on newer models from Chrysler.

On 7/16/26 vehicle would not start; high-pitched noise heard near engine during no-start diagnosis. Towed to Goldy Chrysler Dodge Jeep Ram, Huntington WV. Per dealer invoice #27136: blown 500-amp main battery fuse found; after jumping past fuse, white smoke from exhaust and no coolant in system, diagnosed as blown head gasket. Repair: both-side head gasket replacement plus fuse assembly. Vehicle in shop 7+ weeks, returned 9/4/26 with new unresolved issue: strong smell of burned electronics and antifreeze in cabin. All failed components available for inspection upon request. Safety risk: head gasket failure/coolant intrusion caused engine hydrolock, a sudden uncommanded loss of engine power that can occur without warning, including while driving in traffic. Burned-electronics smell raises electrical/fire risk; antifreeze odor raises cabin fume exposure and window-fogging visibility concerns. Confirmed by dealer: Yes. Goldy diagnosed and documented the fuse failure, coolant loss, and head gasket failure in writing, and performed the repair. Manufacturer/police/insurance inspection: Not by police or insurance. Spoke by phone with a Chrysler HQ rep 5 times (8/13-9/1/26) who was informed; no confirmed independent physical inspection by manufacturer beyond dealer's own diagnosis. Warning signs: P0304 misfire on cylinder 3 appeared first, progressing to complete no-start with high-pitched noise, prompting the tow-in and hydrolock diagnosis.

Electricity light came on as well as overheating light and engine light all at once also stalling