by General Motors, LLC
Oldsmobile Cutlass Recall for Front Problem - (11 Recalls Found)
Find your car listed below. Results are sorted year from newest to oldest. Select the desired vehicle to view the complete details.
Information provided by the National Highway Traffic Safety Administration.
|
|
|
Problem: THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS. Recall Details
Problem: THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS. Recall Details
Problem: THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES." Recall Details
Problem: THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES." Recall Details
Problem: THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT. Recall Details
Problem: THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES." Recall Details
Problem: LEFT HANDED DRIVER'S SIDE SHOULDER BELT ANCHOR PLATE MAY BE UPSIDE DOWN IN LOCK PILLAR SO THAT THE UNTHREADED SLOT OF THE PLATE ALIGNED WITH THE HOLE IN THE LOCK PILLAR. THIS RESULTED IN THE ANCHOR BOLT BEING DRIVEN INTO THE SLOT INSTEAD OF THE THREADED HOLE OF THE ANCHOR PLATE. CONSEQUENCE OF DEFECT: IN A VEHICLE CRASH, BELT ANCHOR BOLT MAY PULL LOOSE FROM ANCHOR PLATE, THUS FAILING TO COMPLY WITH FMVSS 210, SEAT BELT ASSEMBLY ANCHORAGES, AND INCREASES LIKELIHOOD OF INJURY TO OCCUPANT. Recall Details
Problem: THE VEHICLES WERE ASSEMBLED WITH FRONT SEAT BELT RETRACTORS WHICH MAY NOT PERFORM ADEQUATELY DURING A COLLISION. Recall Details
Problem: SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION. Recall Details
Problem: THE INVOVLED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACTS". INCORRECT HEAD RESTRAINTS MAY HAVE BEEN INSTALLED. Recall Details
Problem: UNDER CERTAIN DRIVING CONDITIONS, THESE VEHICLES CAN EXPERIENCE TEMPERATURES IN THE FRONT WHEEL OUTER BEARING AREA WHICH CAN AFFECT THE WHEEL BEARING GREASE. THIS CAN RESULT IN INADEQUATE LUBRICATION OF THE BEARING. THIS CONDITION MAY BE FURTHER AGGRAVATED BY IMPROPER ADJUSTMENT OF THE FRONT WHEEL SPINDLE NUT. Recall Details
|