2016 JEEP WRANGLER Complaints

ABS Control Module stopped working with several warning lights showing on dash display. After 12 months the dealer is unable to supply a replacment part or a possible date when a new part might be available.

The ABS module on my jeep has failed. I've been put on a list to get a replacement part but have been on the list for 10 months with no indication of when my parts order will be fulfilled. The failed ABS module caused the BRAKE, ABS and TCS warning lights to be on. I am driving a vehicle under unsafe conditions and the manufacturer does not care.

My 2016 Jeep Wrangler is experiencing an ongoing problem with the ABS/braking system and wheel-speed sensor. The ABS/brake warning light comes on intermittently, particularly when turning right and during hot weather. The vehicle has NOT been repaired for this problem. I am reporting it because I am concerned that there may be a defect involving the wheel-speed sensor, sensor wiring/connection, wheel hub, or ABS system. Because these components are connected to the vehicle’s anti-lock braking and stability/traction-control systems, I am concerned about the safety of continuing to drive the vehicle. I would like this problem investigated as a potential safety defect. I am also requesting that NHTSA review whether other 2016 Jeep Wrangler owners have reported similar ABS, brake warning light, or wheel-speed sensor failures and determine whether a safety recall is warranted. There was no accident it just started happening on its own.

ABS Brake Sensor is on and the ABS Module needs to be replaced, however there are a lot of other people out there with this same issue and nobody can keep up with the parts to fix the problem. This should be a recall for all Jeeps 2009-10018

The contact owns a 2016 Jeep Wrangler. The contact stated that while driving at an undisclosed speed, the vehicle experienced an ABS module failure. The ABS and traction control warning lights were illuminated. The dealer was contacted and diagnosed the vehicle with ABS control module failure; however, the part to repair the vehicle was not available. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time to provide the parts for the repair. The manufacturer was made aware of the failure but was unable to determine when parts for the repair would be available. The failure mileage was approximately 80,000.

The ABS control module has internal problem which shuts down the module. Results of the module shut down includes: -The stability and traction systems are offline. -A failure in the ABS module or hydraulic unit. -Cruise Control inoperable. -The module no longer modulates brake pressure, which can result in brakes locking. Currently, Mopar has stopped production of this item, so there is no method to replace a failed or non-working module with an original part.

Code C2200 Multiple visits to shop. Part is on indefinite backorder. Brakes lock up when quick needed, traffic/other driver pull out in front of me Showed up 4 months ago

I was driving down the road in a snow storm when all of a sudden the vehicle started swirling all over the road. I pulled over and looked underneath and something was hanging down. I had no choice but to drive it slow less than 10mph to make it home as it was also making a hard jumping. Once there I had my mechanic come look at it and the drive shaft was busted. I am extremely luck that this happened during a snow storm because if not I may have rolled the vehicle as the steering was greatly affected.

ABS module is bad, shooting codes on dash, disable cruise, worried about issues with braking.

The ABS Module is non operative and has been on back order for over 3 years from the Dealership.